Siemens USB LOGO Programming Cable best seller in Bangladesh

Siemens USB LOGO Programming Cable seller in Bangladesh is BD Traders Mart (BDTM). Other Programming Cable ready stock in our warehouse. Encoder seller in Bangladesh

Siemens USB LOGO Programming Cable

• Operating system: Windows7/Windows8/Windows10
• Software version: V4.0, and latest.
• USB version: V2.0.
• Power supply: LOGO Controller Programming port and USB bus.
• Optical isolation: 1000V DC.
• UART data format: Data78
• Stop bit: 12
• Temperature: -20 0C~75 0C.
• Cable Length: 2.5 meters
• Software: Soft Comfort

Siemens USB LOGO Programming Cable Uses:

Connect LOGO! with the LOGO PLC link to a COM port of your PC. Change LOGO PLC to move mode. Switch LOGO into move mode by turning on the LOGO power supply with the LOGO PC
link stopped in. Switch the LOGO! from RUN mode to STOP state by at the same time squeezing the bolt keys? also the OK button. Then, at that point, in the LOGO! show you explore to the “PC/Card..” menu and afterward to the Transfer mode.
Switch the LOGO! from RUN mode to STOP state by squeezing the ESC key. Then, at that point, in the LOGO show, you explore the “PC/Card.” menu and afterward to the Transfer mode. switch your LOGO! into move mode by turning on the LOGO! power supply with the LOGO!- PC link is connected. After startup without the PC link connected,
the LOGO! consequently goes into RUN mode as long as LOGO! has a substantial control program.
The control program must be moved to the LOGO! in the event that the LOGO! is in the STOP state and is in the primary menu and not in a menu discourse.
Switch the LOGO! from RUN mode to STOP state by squeezing the ESC key.If the program move is then started on the PC in LOGO!Soft Comfort, the LOGO! naturally goes into move mode.